T5 Tensiometer

The T5 Tensiometer is specially made for punctual measurements, for example in soil columns, small lysimeters or pots.

With an active surface of only 0,5 cm2 and a diameter of 5 mm the ceramic tip has all advantages of small dimensions: little soil disturbance, punctual pick-up and fast response.
The special version T5x can achieve a measuring range of 200 kPa.

The T5 can be installed in any position and orientation. Bubbles are easily detectable through the transparent shaft. Output signals are balanced.



Typical Applications

  • Punctual measurement of water
    potential
  • Miniature lysimeter studies,
    together with micro samplers and
    soil temperature probes
  • Determination of pF/wc and
    K/Psi in soil columns, soil cores or
    soil sampling rings
  • Determination of leachate and
    capillary water movements
  • Controlling irrigation
  • Pot experiments
  • Measurements in the upper soil horizons in the field
  • Monitoring with data loggers
  • Spot readings with the INFIELD7

Advantages

  • Accurate zero-tension reading
  • Fast response: With sufficient fillingthe T5 responds within 5 seconds to an applied air pressure change of 0 to 85 kPa
  • Most standard T5 reach a range of at least 150 kPa when delivered.

Limitations

  • Not for dry soils
  • Not frost resistant
  • In the field applications require impact protection

Technical Information

Measuring range +100 kPa ... -85 kPa
Output signal -100 ... +85 mV
Accuracy ±0.5 kPa
Supply typ. 10.6 VDC / 1.3 mA
Shaft Ø 5 mm
Shaft length 2 ... 20 cm
Corpus Ø 20 mm, length 3.5 cm
Cable 1,5 m; 4-pin plug M12

Included in Delivery

  • T5 in carrying case
  • refill tools
  • Manual
T5 Tensiometer
T5 Tensiometer
T5 Tensiometer


T5 Tensiometer

Special T5x

The T5x is the first pressure transducer Tensiometer that can reach an expanded measuring range of up to 200 kPa when it is specially filled (see fig. and ordering information).
Response and filling though are reduced compared to a standard T5.



Order information

Indicate required shaft length on an order, e. g. 7 cm = T5-7



UMS
measure to know